- ページ 9

無線アクセスポイント Cisco WAP131のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco WAP131 13 ページ。 Reboot and reset factory default settings
Cisco WAP131 にも：クイック・スタート・マニュアル (13 ページ), マニュアル (4 ページ), マニュアル (4 ページ)

ページを印刷する

Because the factory default IP address configuration is DHCP, make sure

that your DHCP server is running and can be reached. You may need to

disconnect and reconnect the devices for them to discover their new IP

addresses from the DHCP server. You can then query the DHCP server for

the new IP address. See

Configuration"

If the Cisco WAP131 does not receive a DHCP response (there is no DHCP

server on your network) after 60 seconds, the Cisco WAP131 will fallback

to the following default static IP address: 192.168.1.245 and a default mask

of 255.255.255.0. To reach that IP address, be sure that your computer is

on the 192.168.1.xxx network.

Rebooting the Cisco WAP131 or Resetting

to Factory Defaults

To reboot your Cisco WAP131:

• If the Cisco WAP131 uses a power adapter, with the power on, use the

POWER button to reboot the device. The POWER button only functions

when the Cisco WAP131 uses a power adapter.

• If the power supply is PoE, unplug your Ethernet connection for three

seconds and plug it back in.

• With the power on, press the RESET button with an opened paper clip

for less than 10 seconds, or until the lights go off.

–

When all the lights go off, release the RESET button.

–

Release the RESET button as soon as the lights go off, or you will

restore the Cisco WAP131 to factory default settings and lose your

configurations.

To reset the Cisco WAP131 to factory default settings:

• With the power on, press and hold the RESET button with an opened

paper clip for more than 10 seconds.

–

All of the lights will go off.

–

Release the RESET button when the power light turns on.

Cisco WAP131 Quick Start Guide

Step 2

for more information on how to find the DHCP address.

"Getting Started with the