- ページ 8

ネットワーク・ハードウェア Cisco 6160のPDF インストール手順マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 6160 32 ページ。 Without a pots splitter configuration
Cisco 6160 にも：クイック・リファレンス・マニュアル (38 ページ), ハードウェア・インストール・マニュアル (21 ページ), 取り付けと交換に関する注意事項 (18 ページ)

Installation Procedures

4.2.4.2 Ground the Cisco 6160 from the Power Terminal Block Connector

Warning

When you are installing or replacing the Cisco 6160 chassis, the ground connection must always be

made first and disconnected last.

To ensure adequate earth ground for the system, complete the following steps to attach the grounding

wire to the power terminal block connector on the Cisco 6160 backplane:

Verify that power in the DC circuit is off.

Step 1

Measure enough wire to connect the Cisco 6160 to the grounding point at your site or to the rack.

Step 2

Note

Use a wire stripper to remove the casing from both ends of the grounding wire.

Step 3

Identify the correct power terminal block on the backplane of the Cisco 6160. The PWR 1 connector is

Step 4

used if you have a primary power entry module (PEM) installed in the chassis. The PWR 2 connector is

used if you have a secondary (redundant) PEM installed in the chassis.

the PWR 1 and PWR 2 power terminal block connectors.

Cisco 6160 Hardware Installation Guide

4-8

See

Table 2-4

for wire specifications.

Chapter 4

Installing a Cisco 6160 Without a POTS Splitter Configuration

Figure 4-4

shows the location of

OL-2190-02 B0