- ページ 5

ネットワーク・ハードウェア Cisco 7200-I/O-2FE/EのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 7200-I/O-2FE/E 16 ページ。 Input/output controllers

Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers

Use the interface fastethernet router-shelf/slot/port command for a Cisco 7200 VXR used as a router shelf in an AS5800 Universal Access

Server.

Verifying the Configuration

Use the show interfaces {ethernet | fastethernet | gigabitethernet} command to verify that the

interface and line protocol are in the correct state (up) and the transmission mode is configured on the

interface. You can configure full, half, or auto transmission mode for Ethernet and Fast Ethernet

interfaces. You can configure forced transmission mode for Gigabit Ethernet interfaces. The following

example displays sample output for a show interfaces gigabitethernet command.

Router# show interfaces gigabitethernet 0/0

GigabitEthernet0/0 is up, line protocol is up

Hardware is 82543 (Livengood), address is 00d0.ffb6.4c00 (bia 00d0.ffb6.4c00)

Internet address is 10.1.1.0/0

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex mode, link type is autonegotiation, media type is SX

output flow-control is on, input flow-control is on

ARP type:ARPA, ARP Timeout 04:00:00

Last input 00:00:04, output 00:00:03, output hang never

Last clearing of "show interface" counters never

Queueing strategy:fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

2252 packets input, 135120 bytes, 0 no buffer

Received 2252 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 0 multicast, 0 pause input

0 input packets with dribble condition detected

2631 packets output, 268395 bytes, 0 underruns

0 output errors, 0 collisions, 2 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 pause output

0 output buffer failures, 0 output buffers swapped out

Configuration Tasks

12.1(5)T and 12.2(14) S