- ページ 4

デジタルカメラ Sony TS-DSC-P41-01のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Sony TS-DSC-P41-01 12 ページ。 Sony camera tracksnap manual

TrackSnap Manual

When turning power on to your TrackSnap both the red and green LED will light up. They will both stay on

for 30 seconds. This time will allow the PIR circuit to warm up. After this time expires the green LED will turn

off and the red LED will blink 5 times letting you know that the board is entering a 1 minute automatic walk-

test phase. At this point you can move around the camera setup and check out the PIR area. Both the green

and red LED's will light when motion is detected. After the 1 minute automatic walk-test phase expires the

red LED will blink 5 times letting you know the camera system will now become active.

Version

TS P41.2

This document comprises information provided by Suppliers and is

To adjust the PixController PIR detection range

simply turn the single turn POT shown to the left to

your desired range. The default setting is in the

middle, as shown. The two "dots" on the Philips head

screw show the actual location.

The default setting is desirable for almost all weather

conditions. In very hot summer months, or setups

over fields with no shading cover you should reduce

the PIR sensitivity.

Note: Turning the sensitivity to the minimum setting

will turn the PIR detection off.

When adjusting the Day/Night Sensor POT you

must first set the DIP switches 3 & 4 "Up" when the

board is powered down, and then turn the board

on. The "Red Control LED" will light up when the

detection level detects darkness. You may want to

adjust this in the darkest setting you want to run

your system at when adjusting this POT. When

finished you will need to return DIP switches 3 & 4

back to their original setting.

Page 4 of 12

assumed to be correct.

Model TS-DSC-P41-01

Released