- ページ 9
ネットワーク・ハードウェア Cisco ASA 5545-XのPDF ソフトウェアマニュアルをオンラインで閲覧またはダウンロードできます。Cisco ASA 5545-X 37 ページ。 Threat defense reimage guide
Cisco ASA 5545-X にも： 取付説明書 (13 ページ), クイック・スタート・マニュアル (13 ページ), クイック・スタート・マニュアル (15 ページ)
ページを印刷する
Cisco ASA and Firepower Threat Defense Reimage Guide
ADDRESS=10.86.118.3
NETMASK=255.255.255.0
SERVER=10.86.118.21
GATEWAY=10.86.118.21
VLAN=untagged
IMAGE=ftd-boot-latest.lfbff
CONFIG=
LINKTIMEOUT=20
PKTTIMEOUT=4
RETRY=20
rommon 6 > sync
Updating NVRAM Parameters...
rommon 7 > tftpdnld
Ping to troubleshoot connectivity to the server:
rommon 1 > ping 10.123.123.2
Sending 10, 32-byte ICMP Echoes to 10.123.123.2 timeout is 4 seconds
!!!!!!!!!!
Success rate is 100 percent (10/10)
rommon 2 >
Step 6
Enter setup, and configure network settings for the Management interface to establish temporary connectivity
to the HTTP or FTP server so that you can download and install the system software package.
Note
Example:
firepower-boot>
firepower-boot>setup
Welcome to Cisco FTD Setup
[hit Ctrl-C to abort]
Default values are inside []
Enter a hostname [firepower]: example.cisco.com
Do you want to configure IPv4 address on management interface?(y/n) [Y]: y
Do you want to enable DHCP for IPv4 address assignment on management interface?(y/n) [Y]:
n
Enter an IPv4 address: 10.123.123.123
If you have a DHCP server, the FTD automatically sets the network configuration. See the following
sample startup messages when using DHCP:
Configuring network interface using DHCP
Bringing up network interface.
Depending on your network, this might take a couple of minutes when using DHCP...
ifup: interface lo already configured
Using IPv4 address: 10.123.123.123
Using IPv6 address: fe80::2a0:c9ff:fe00:0
Using DNS server: 64.102.6.247
Using DNS server: 173.36.131.10
Using default gateway: 10.123.123.1
Cisco FTD Boot 6.3.0
Type ? for list of commands
Reimage from ASA to Firepower Threat Defense
Cisco ASA and Firepower Threat Defense Reimage Guide
9