- ページ 9

ネットワーク・ハードウェア Cisco PIX 506EのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco PIX 506E 18 ページ。 Chapter 3
Cisco PIX 506E にも：クイック・スタート・マニュアル (17 ページ), ユーザーマニュアル (8 ページ)

ページを印刷する

PDM version 2.0 and higher releases include a Startup Wizard for initial configuration. Follow these steps

to load PDM and use the Startup Wizard:

Use an Ethernet cable to connect your PC to the inside port (Ethernet 1) on the rear panel of

Step 1

the PIX Firewall.

Configure your PC to use DHCP (to receive an IP address automatically from the

Step 2

PIX Firewall) or assign a static IP address to your PC by selecting an address out of the

192.168.1.0 network.

The inside interface of the PIX Firewall is assigned 192.168.1.1, so choose a different

Note

IP address.

Check the ACT LED on the rear panel of the PIX Firewall (see Table 2 on page 6) to verify

Step 3

that your PC has basic connectivity to the inside port (Ethernet 1). When connectivity occurs,

the ACT LED next to the port lights up solid green.

To access the Startup Wizard, use a PC connected to the inside port and enter the URL

Step 4

https://192.168.1.1/startup.html into your browser.

It is very important to enter the "s" in "https://192.168.1.1," which indicates

Note

a secure connection. If you enter "http://192.168.1.1" without the "s" in

"https," you cannot access the PIX Firewall.

Accept the certificates and follow the instructions in the Startup Wizard. For online help, click

Step 5

the Help button at the bottom of the Startup Wizard window.