- ページ 3

ネットワーク・ハードウェア Cisco SCE 1000 andのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco SCE 1000 and 49 ページ。 Service control engine 1000 2xgbe

• Grounding kit (shipped with the SCE 1000)

• 12 AWG or 2.5 mm copper installation wire with hex or loop connectors for DC power leads (DC power only) Ring

terminals must be UL approved and suitable for 12 AWG wire.

• AC power cords (AC power only, shipped with SCE 1000)

• Rack-mounting kit (shipped with SCE 1000)

Spare screws for changing bracket position

–

Prepare for Rack-Mount Installation

Before you begin the rack-mounting tasks, determine the type of rack—four-post or two-post—that you will be using.

Figure 1

Tabletop Installation of the SCE 1000 Platform

BYP ASS

STA TUS

PW R B

LIN K RX

PW R A

GBE -1

LIN E

AU X

SUB

CO NSO

MN G 2

MN G 1

10/1 00/

LINK /

10/1 00/

ACT IVE

1000

ACT IVE

For a workbench or tabletop installation, verify the following before installing the SCE 1000 platform:

• The SCE 1000 platform is off the floor and has adequate ventilation.

• An adequate chassis ground (earth) connection exists for the SCE 1000 platform.

• The SCE 1000 platform has at least 2 inches (5 cm) of clearance at each side and at least 5 inches (12.7 cm) of clearance at

the rear to allow proper air flow.

Remove the adhesive strips from the four rubber feet and affix the feet onto the four marked locations on the bottom

Step 1

panel of the unit.

Step 2

Place the SCE 1000 platform on the tabletop or workbench.

Se rie s

C E 1 0 0

C is co S

2 xG B E

LIN K RX

NET