- ページ 7
ネットワーク・ハードウェア Cisco TelePresence Server 7010のPDF 交換取扱説明書をオンラインで閲覧またはダウンロードできます。Cisco TelePresence Server 7010 18 ページ。 600w ac-input power supply and fan tray replacement
Cisco TelePresence Server 7010 にも: 交換取扱説明書 (23 ページ), 取付説明書 (15 ページ), インストレーション・マニュアル (14 ページ), はじめに (16 ページ)
Tools and Equipment
This section lists the tools and equipment you will need to complete these replacement procedures.
Have the following tools on hand so that you can complete the replacement without interruption:
•
3/16-inch, flat-blade screwdriver to loosen the captive screws on the chassis cover panel
•
Number 1 Phillips screwdriver to remove the M3 Phillips screws on the power harness cover (you
must remove the power harness cover to replace the power supply)
•
Number 2 Phillips screwdriver to remove the M4 Phillips screw on the power supply and the fan
tray
•
Antistatic mat or antistatic foam pad if you are replacing the fan tray
•
Your own ESD grounding strap or the disposable ESD strap that is included with all spares
If the chassis is mounted in an equipment rack, ensure that there is at least 1 foot of clearance at the
noninterface processor end to remove the power supply or fan tray, both of which you must pull
straight out of the chassis.
If a power strip or other equipment obstructs access, you will have to remove the chassis from the
rack before replacing the component. Refer to the Cisco 7010 Hardware Installation and
Maintenance or Cisco 7505 Hardware Installation and Maintenance publications for the tools you
will need and descriptions of the rack mounting hardware.
600W AC-Input Power Supply and Fan Tray Replacement Instructions
Prerequisites
7