- ページ 16

ネットワーク・ハードウェア Cisco UBR7246VXRのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco UBR7246VXR 27 ページ。 Universal broadband router
Cisco UBR7246VXR にも：ユーザーマニュアル (7 ページ), インストレーション・マニュアル (28 ページ), ハードウェアのインストール (25 ページ)

AC Power Supplies

Step 1

At the rear of the router, ensure that the power switch on the power supply is in the OFF (0) position.

Step 2

Slide the cable-retention clip to the left, away from the AC receptacle, and plug in the power cable.

Secure the cable in the power supply AC receptacle by sliding the cable-retention clip to the right until it fits around

Step 3

the connector. The cable-retention clip provides strain relief for the AC power cable.

For additional AC power cable strain relief, secure the cable to the power supply handle by inserting a nylon cable tie

Tip

through the hole in the handle and around the cable.

Plug the AC power supply cable into the AC power source.

Step 4

Repeat Step 1 through Step 4 for the second power supply (if present).

Step 5

Figure 11

Connecting AC-Input Power

Power

receptacle

Captive

installation

screw

AC power cable

Warning

Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement

1003

Warning

When installing or replacing the unit, the ground connection must always be made first and disconnected last.

Statement 1046

Warning

A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement 1022

Note

The color-coding of the DC-input power supply leads depends on the color-coding of the DC power source at your site.

Typically, green or green/yellow is used for ground, black is used for +48V (return), and red or white is used for –48V.

Make certain that the lead color-coding you choose for the DC-input power supply matches lead color-coding used at

the DC power source.

Power

switch

Handle