- ページ 14

サーバー Cisco ONS 15454のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Cisco ONS 15454 22 ページ。 Four-shelf and zero-shelf bay assembly
Cisco ONS 15454 にも：インストール (32 ページ), インストール (32 ページ), 開梱と設置 (42 ページ), 開梱と設置 (40 ページ)

ページを印刷する

NTP- A274 Install the FC_MR-4 Card

If you installed XCVT cards, review

Step 1

installed XC10G or XC-VXC-10G cards, review

compatibility.

Step 2

Open the card latches/ejectors.

Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the

Step 3

receptacle at the back of the slot.

Note

Step 4

Verify that the card is inserted correctly and close the latches/ejectors on the card.

Note

Verify the LED activity:

Step 5

•

The red FAIL LED turns on for 20 to 30 seconds. The ACT LED is amber for 3 to 5 seconds.

•

The red FAIL LED blinks for up to 2 minutes.

•

The FAIL and ACT LEDs blink once and turn off for 1 to 5 seconds.

The ACT LED turns on green.

•

Note

Complete the

Step 6

the FC_MR-4 card.

Note

Step 7

Continue with the

Stop. You have completed this procedure.

Cisco ONS 15454 Procedure Guide, R8.0

2-14

If you install the wrong card in a slot, complete the

procedure on page 2-20

and install the correct card.

It is possible to close the latches/ejectors when the card is not completely plugged into the

backplane. Ensure that you cannot insert the card any further.

If the red FAIL LED does not turn on, check the power.

If you insert a card into a slot provisioned for a different card, all LEDs turn off.

"DLP-A469 Install a GBIC or SFP/XFP Device" task on page 21-57

If you need to remove a GBIC or SFP/XFP, complete the

SFP/XFP Devices" task on page

"NTP-A247 Install Fiber-Optic Cables" procedure on page

Table 2-1 on page 2-3

to determine card/slot compatibility. If you

Table 2-2 on page 2-5

"NTP-A116 Remove and Replace a Card"

21-59.

Chapter 2 Install Cards and Fiber-Optic Cable

to determine card/slot

to install GBICs on

"DLP-A470 Remove GBIC or

2-16.

78-17697-01