- ページ 6

サーバー Cisco TelePresenceMCU 5300 SeriesのPDF はじめにをオンラインで閲覧またはダウンロードできます。Cisco TelePresenceMCU 5300 Series 20 ページ。 Multipoint control units

ページを印刷する
Cisco TelePresenceMCU 5300 Series はじめに

Connecting the MCU

Before you start

IMPORTANT
information at

Step one: Connect power

Connect the power connector on the rear of the unit to the power supply using the
supplied power cable. (There is no On/Off switch.)

Step two: Connect to Ethernet Port A

Connect an Ethernet cable from Ethernet Port A to an Ethernet switch.
Only connect to Ethernet Port B if you need to connect the MCU to a
i
second subnet.
Do not connect Ethernet Port A and Ethernet Port B to the same subnet.
!
Failing to configure both sides of the Ethernet connection in the same
!
way can result in packet loss leading to poor audio and video quality.
: Before installing the MCU, you must read the safety
http://www.cisco.com/go/telepresence/safety
Connecting the MCU
.
6