サーバー Cisco UCS B200 M4のPDF 整備マニュアルをオンラインで閲覧またはダウンロードできます。Cisco UCS B200 M4 24 ページ。 For e5-2600 v4 series cpus
Cisco UCS B200 M4 にも： インストールとサービスノート (30 ページ), インストールとサービスノート (46 ページ), アップグレードマニュアル (9 ページ)
ページを印刷する
Servicing a Blade Server
This chapter contains the following sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Replacing a Drive
The Cisco UCS B200 M4 blade server uses an optional Cisco UCS FlexStorage modular storage subsystem
that can provide support for two drive bays and RAID controller, or NVMe-based PCIe SSD support
functionality. If you purchased the UCS B200 M4 blade server without the modular storage system configured
as a part of the system, a pair of blanking panels may be in place. These panels should be removed before
installing hard drives, but should remain in place to ensure proper cooling and ventilation if the drive bays
are unused.
You can remove and install hard drives without removing the blade server from the chassis.
The drives supported in this blade server come with the hot-plug drive sled attached. Empty hot-plug drive
sled carriers (containing no drives) are not sold separately from the drives. A list of currently supported drives
is in the
Before upgrading or adding a drive to a running blade server, check in the service profile and make sure the
new hardware configuration will be within the parameters allowed by the service profile.
Replacing a Drive, on page 1
Removing a Blade Server Cover, on page 4
Air Baffles, on page 5
Internal Components, on page 5
Diagnostics Button and LEDs, on page 6
Installing a CMOS Battery, on page 7
Installing the FlexStorage Module, on page 8
Upgrading to Intel Xeon E5-2600 v4 CPUs, on page 9
Removing a Heat Sink and CPU, on page 10
Installing a New CPU and Heat Sink, on page 11
Installing Memory, on page 14
Installing a Virtual Interface Card Adapter, on page 17
Installing the NVIDIA M6 GPU Adapter Card, on page 19
Enabling the Trusted Platform Module, on page 22
Cisco UCS B200 M4 Blade Server Specification
Sheet.
Servicing a Blade Server
1