- ページ 22

サーバー Cisco UCS E SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco UCS E Series 46 ページ。 Ucs e series unified computing system
Cisco UCS E Series にも：製品概要 (8 ページ), トラブルシューティングマニュアル (28 ページ)

ページを印刷する

Installing the E-Series Servers

Installing the Blank Faceplates

All empty chassis slots on the router must be covered with blank faceplates to ensure proper cooling and

airflow and to prevent electromagnetic interference.

Use this procedure to install a blank faceplate on a router's service module (SM) slot.

Procedure

For a single-wide E-Series Server—Install a slot divider in the SM slot. See the

Step 1

Dividers" section on page

Install the blank faceplate as shown in the figure below.

Step 2

•

Figure 7

Preparing the Router Slot for E-Series Server Installation

Several Cisco routers have flexible SM slots to support various Cisco server modules. Before installing

the E-Series Server or SM E-Series NCE into the router, prepare the router's SM slot for the server's

particular form factor.

Slot dividers are used on the following routers:

•

By default, the slot dividers are preinstalled in the router. Depending on the type of server that you want

to install, you must either install or remove the slot divider from the router.

Note

•

Hardware Installation Guide for Cisco UCS E-Series Servers

23.

For blank faceplates with mounting screws—Align the captive screws with the screw holes on the

chassis. Using either a number 1 Phillips screwdriver or a small flat-blade screwdriver, tighten the

captive screws until the blank faceplate is flush with the chassis.

For blank faceplates with tabs—Align the blank faceplate tabs with the slots on the chassis. Press

the blank faceplate against the chassis until the tabs pop into place. The blank faceplate must be

flush with the chassis when installed.

Blank Faceplate

DO NO T

RE MO VE

NE TW OR

DU RIN G

K OP ER

AT ION

Cisco 2921, and 2951 series ISR G2

Cisco 3925, 3925e, 3945, and 3945e ISR G2

To replace a double-wide E-Series Server with a single-wide E-Series Server or SM E-Series NCE,

you must install a slot divider.

To install the double-wide E-Series Server, you must remove the slot divider.