- ページ 8

ゲートウェイ Cisco ISDN GW 3241のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco ISDN GW 3241 15 ページ。 High performance video gateway which enables isdn network connectivity for cisco telepresence ip
Cisco ISDN GW 3241 にも：はじめに (17 ページ)

ページを印刷する

Initial configuration

Step one: Connect to the console port

Ensure power is connected to the ISDN GW 3241 and the Status LED is green.

Connect the console port of the ISDN GW 3241 to the serial port of your PC

using the blue RJ45 to DB9 console cable supplied.

Use a serial terminal program, such as Secure CRT or HyperTerminal, to

connect to the ISDN GW 3241. Set your terminal software to the following

settings:

Baud rate:



Data bits:



Parity:



Stop bits:



Flow control:



Press Enter and the following command prompt appears on the terminal:

ISDN-GW:>

Step two: Configure Ethernet Port A settings

The default setting for the ISDN GW 3241 Ethernet ports is auto-sensing mode. If

the switch ports to which you connect the ISDN GW 3241 are not also set to auto-

sensing mode, then you need to configure the ISDN GW 3241 Ethernet ports to use

the same speed and duplex mode.

Only connect to Ethernet Port A, as all initial configuration must be done

on this port. Do not connect anything to Ethernet Port B.

Both ends of the Ethernet connection must be configured in the same

way. For example, either configure both ends of the link to be auto-

sensing or configure both ends to operate at the same speed and duplex.

To establish a 1000 Mbps connection, both ends of the link must be

configured as auto-sensing.

38400

none

Initial configuration