- ページ 2

スキャナー Epson Perfection J141AのPDF 重要な安全上のご注意をオンラインで閲覧またはダウンロードできます。Epson Perfection J141A 4 ページ。 Notices

Unplug the scanner and the AC adapter, and refer servicing to qualified service personnel
under the following conditions: The power cord or plug is damaged; liquid has entered the
scanner or the AC adapter; the scanner or the AC adapter has been dropped or the case
damaged; the scanner or the AC adapter does not operate normally or exhibits a distinct change
in performance. (Do not adjust controls that are not covered by the operating instructions.)
Unplug the scanner and the AC adapter before cleaning. Clean with a damp cloth only. Do not
use liquid or aerosol cleaners.
If you are not going to use the scanner for a long period, be sure to unplug the AC adapter from
the electrical outlet.
To reduce the risk of fire, use only the included power cord or a 6 to 10 foot long UL-approved
type SPT-2 or heavier, 2 x 18 AWG cord with a 125 V 10 A plug and 125 V 7 A connector.
If your AC adapter is equipped with a polarized alternating-current line plug (a plug having
one blade wider than the other) and a polarized power inlet, the plug only fits into a power
outlet in one way. This is a safety feature. If you are unable to insert the plug properly, try
reversing the plug. If this fails again, contact an electrician to replace your outlet. Be sure to use
only the polarized power cord that comes with the scanner.
This product includes a lamp component that contains mercury. Please consult your state and
local regulations regarding proper disposal or recycling. Do not put in the trash.

FCC Compliance Statement

For United States Users

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio or television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to
radio and television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING: The connection of a non-shielded equipment interface cable to this equipment will
invalidate the FCC Certification of this device and may cause interference levels which exceed the
limits established by the FCC for this equipment. It is the responsibility of the user to obtain and
use a shielded equipment interface cable with this device. If this equipment has more than one
interface connector, do not leave cables connected to unused interfaces. Changes or modifications
not expressly approved by the manufacturer could void the user's authority to operate the
equipment.