- ページ 5

屋外ライト Acuity Brands Lighting Holophane Wallpack HLWCP2のPDF インストレーション＆メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。Acuity Brands Lighting Holophane Wallpack HLWCP2 6 ページ。 Full cutoff led luminaire

ページを印刷する

HOLOPHANE

2.7 Optional 0-10V DC Dimming Controls Information

2.7.1 Certain control options available with the

Wallpack® Full Cutoff LED luminaire have 0-10V DC

dimming capabilities. General information for each is as

follows:

2.7.2 For the field adjustable output (AO) module, the

default setting is position 8 on the dial, which

corresponds to 100% output. Output and can be

adjusted by rotating the center dial. See tables 2-6 for

additional dial settings and their corresponding outputs

based on performance package. AO Tables are included

on the last page of this installation manual.

2.7.3 For the occupancy sensor options (MASL &

MASH), see luminaire spec sheet for specific mounting

height information but in general the MASL option

mounting height should not exceed 15' and the MASH

option mounting height should be between 15-30' –

Specific programming instructions for these devices is

included in a separate document, included with the

luminaire.

2.7.4 The part-night dimming (PND) option requires no

special steps – the device comes preprogrammed.

2.7.5 For the NEMA twist-lock photocontrols (P3 and P7

options), installed control nodes are sold separately and

are not supported by Holophane product support.

3 Maintenance

3.1 Electrical Component Replacement

3.1.1 Disconnect power to the luminaire location before

maintenance.

3.1.2 Open luminaire by loosening 6 heatsink screws

and removing the heatsink from the electrical housing.

Depending on the device being serviced/replaced it may

be easiest to completely remove the heatsink from the

electrical housing. Drivers and fuses are mounted to the

heatsink, surge devices are mounted to the electrical

housing.

3.1.3 Tag leads before disconnecting if they are not

already labeled.

3.1.4 Replace components using Holophane approved

replacement parts.

3.1.5 Re-connect electrical leads. See sections 2.3, 2.4,

or 2.5 depending on luminaire configuration.

3.1.6 Reattach heatsink to electrical housing. See

section 2.6.

3.2 Heatsink - Optical Housing

3.2.1 There are no user serviceable parts in the optical

housing portion of the heatsink.

4 Limited Warranty and Limitation of Liability

4.1 5-year limited warranty. Complete warranty terms

located at:

www.acuitybrands.com/CustomerResources/Terms_and

_Conditions

Wallpack

LED Luminaire (HLWPC2)

Full Cutoff

Installation and

Maintenance

Manual

IM‐438‐B