- ページ 3

照明器具 Acuity Brands Lighting Lithonia Lighting TWP-LED SeriesのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Acuity Brands Lighting Lithonia Lighting TWP-LED Series 4 ページ。

ページを印刷する

Installation Instructions

TWP-LED

Outlet box mounting:

1. Loosen the 2 captive screws in the front housing and remove front cover from fixture.

2. Remove electrical splice compartment cover. Keep (2) 8-32 screws for reinstallation.

3. Remove center knock out and feed wires through.

4. Mount fixture using dimensions shown in Figure A.

4a. If provided with an ALO device, adjust the dial to the required lumen level (use ALO table as reference), by turning it using

a small flat head screwdriver.

5. Make supply connections. Reinstall the (2) 8-32 screws and electrical splice component cover removed in step 2, making

sure no wires are pinched.

6. Replace front cover.

7. Tighten the 2 captive screws (30-35in lbs). Do not over tighten. Over tightening will cause stripping and void all warranties.

Electrical splice

compartment

cover

Condulet Tee mounting:

1. Loosen the 2 captive screws in the front housing and remove

front cover from fixture.

2. Remove electrical splice compartment cover and driver

cover. Keep (2) 8-32 and (2) 10-24 screws for reinstallation.

3. Remove top conduit cover disc.

4. Mount fixture using dimensions shown in Figure A. Thread

conduit into fixture.

5. Make supply connections. Reinstall both compartment

cover and driver cover using (2) 8-32 and (2) 10-24 screws

removed in step 2, making sure no wires are pinched.

6. Replace front cover.

7. Tighten the 2 captive screws. Do not over tighten. Over

tightening will cause stripping and void all warranties.

DELIVERY: Upon receipt of fixture and accessories (packed separately), thoroughly inspect

for any freight damage. All damage should be reported to the delivery carrier. Compare

the catalog description listed on the packing slip with the fixture label on the inside of

the housing to be sure you have received the correct merchandise.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

3/8" KO (3)

15-1/4"

7/8"

5 year limited warranty

15-3/4"

2-7/8"

1-13/16"

4-1/4"

2-1/2"

Conduit cover disc