ロックス ARGSeguridad L100IIのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。ARGSeguridad L100II 2 ページ。
ページを印刷するL100II INSTALLATION INSTRUCTIONS
Product And Accessories
A Front panel
B Back panel
C Lock Bolt and Fixed Screws
D Rubber Mat and Fixed board
(4 long screws to attach front panel)
(2 short screws to attach back panel)
E Latch Strip
F Emergency keys and RFID card
Preparation Before Installation
1. Door type: Wooden door;
2. Door open method: left-hand and right-hand. Please verify and adjust it before installation.
3. Please follow the below steps to change the handled:
1 Left handle
Installation
Step 1
Insert Latch Strip in door is shown in
the diagram.
* See Note 1
Step 5
Connect the wire loom from the Front
Panel to Back Panel and remove the
battery cover.
A
D
Door thickness: 35-50mm;
2 Remove the
handle's screw.
Step 2
Install the Front Panel with Rubber
Mat on the door and route wire loom
ABOVE the Latch.
* See Note 2
Step 6
Remove screws which have been
installed on the Fixed Board before,
and fasten Back Panel to the fixed
board.
DO NOT OVER TIGHTEN IT.
B
E
Left handle
3 Change handle
direction and replace
the screw into hole of
the handle.
Step 3
Install Fixed Board with Rubber Mat
and route wire loom through left hole.
Recommendation: Install 2 screws
on the Fixed Board to fixed position.
Step 7
Fasten last two screws on the Back
Panel.Turn the handle to make sure
that you can unlock the door with the
handle. Then tighten all the screws on
the lock and Install alkaline batteries
and replace the battery cover.
C
F
Right handle
4 Right handle
Step 4
Install the Lock Bolt through the Latch
Strip and make sure the Lock Bolt is
pluged in the Front Panel.
* See Note 3
Note 1: Make sure you install
new Strike Plate on door frame
and cut hole appropriately. It
maybe necessary to enlarge
existing hole.
Note 2: Make sure the Front
Panel on door frame and cut
hole appropriately and buttom
brace screw need through the
latch hole.
Note 3:
Latch and Back Thumb
Turn should be in unlocked
position.