- ページ 16

モデム Motorola HPD 1000のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Motorola HPD 1000 34 ページ。

Status Applet and Features

Power Management

There are four available ways to control the ON/OFF cycle for HPD:

• Computer Communication Cable (USB or Ethernet or Both)

• Front Button Press

• Ignition

• Battery Voltage Level

Note: ONLY Igniton and Battery Voltage are required conditions for

the other two to work.

Assuming Ignition is attached to the car's ignition and the Car's

ignition is in the ON position, and the power cable is attached to a

fully charged Battery, then the following is true:

Your Modem will turn ON and stay ON when a

Communication Cable is connected between a powered-

up computer (includes standby or sleep modes) with the

HPD modem.

Your modem will turn ON and stay ON with the press of

the Power Button even If there is no Communication Cable

attached or the computer is OFF (or in hibernation mode).

If your Modem was turned on via a Power Button Press

(without an active Communication Cable attached), it can

be turned OFF via a subsequent Button Press.

Note: This occurs ONLY after your modem has initialized and

showing a flashing green LED, which is about 6

seconds after the initial button press.

If an active Communication Cable is attached after your

modem was turned on via a button Press (without an

active Communication Cable attached), it will remain ON

from any subsequent button presses.

Note: Your modem will only turn OFF either by removing the

communication cable or turning the computer off.