- ページ 6

バスタブ Ariel ARL-702のPDF インストレーション＆ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ariel ARL-702 16 ページ。 Whirlpool

ページを印刷する

22. Ensure the water supply lines for this product has its own dedicated water

shutoff valves installed in an accessible location.

23. Ensure there is enough space and access to connect, adjust or fasten the

various supply lines, waste line and other components.

24. Be sure to check each installation step with this manual to ensure the prod-

uct is installed correctly. The product must be installed with all the feet or sup-

portive legs touching the floor before any use. Leveling the product is an impor-

tant procedure and must be completed on-site – on the installation surface and

final installation position.

25. Always double-check all connections to ensure for proper installation, ten-

sion, and connection, including parts, plugs, hoses, nuts, screws, wires, etc.

26. Only a professional electrician is recommended to work on the high voltage

portions of installation and testing.

27. Electrical service must meet the requirements listed on the components of

the product, listed within this manual, or otherwise advised based on a thorough

analysis of any special circumstances.

28. An electrical protection device for short-circuits, power overloads or incor-

rect voltage must be installed and used in conjunction with this product.

29. This product or any appliance used near this product must be used in con-

junction with a Ground Fault Circuit Interrupter ("G.F.C.I." or "G.F.I.") or Resid-

ual Current Device ("R.C.D.") with a trip current of not greater than 30mAor oth-

erwise required in accordance to local codes.

30. Do not cut or extend electrical wires or power-cord of the product without

the approval of a professional electrician and warranty service representative.

31. Appliances or components with ground or "earth" connections must be in-

stalled and used in conjunction with the product, and connected in accordance

to local codes.

32. The motor must be grounded with wire not less than 14awg (1.63mm-diam-

eter) or otherwise required in accordance to local codes.

33. Check local and national requirements before installing or purchasing this

product.

34. Local standards and codes must be followed and cannot be the responsibil-

ity of the supplier or its distributors.

35. Other electrical components, except the remote control device (optional),

should be kept, located or affixed away from the product, so they cannot fall

into the bath, while in use.

36. Do not disassemble the control panel or computer controller as it is not de-

signed for disassembly. Defects, damages or shock caused by such removal

cannot be the responsibility of the supplier or its distributors.

37. "H" hot (red) and "C" cold (blue) water supply connections and their orienta-

tion are critical to proper function of this product.

38. Ensure the (optional) "H" hot (red) and "C" cold (blue) water hoses will not

touch the floor when this product is fully installed, as it may cause rusting and

possibly weakening of those hoses.

39. Harsh chemicals such as acetone, ammonia or gasoline can possibly dis-

solve or damage portions of this product – do not use such chemicals for clean-

ing or installing this product.

40. Do not stack anything on top of this product, use it for support, or apply any

extreme pressure to critical areas that may cause misalignment or damage;

take special care when moving this product.