- ページ 5

オール・イン・ワン・プリンター Toshiba E-studio 2050cのPDF 安全情報マニュアルをオンラインで閲覧またはダウンロードできます。Toshiba E-studio 2050c 32 ページ。 Multifunctional digital color systems

ページを印刷する

End User Software License Agreement

INSTALLING OR OTHERWISE USING THIS SOFTWARE PRODUCT CONSTITUTES YOUR

ACCEPTANCE OF THE FOLLOWING TERMS AND CONDITIONS (UNLESS A SEPARATE LICENSE IS

PROVIDED BY THE SUPPLIER OF APPLICABLE SOFTWARE IN WHICH CASE SUCH SEPARATE

LICENSE SHALL APPLY). IF YOU DO NOT ACCEPT THESE TERMS, YOU MAY NOT INSTALL OR USE

THIS SOFTWARE, AND YOU MUST PROMPTLY RETURN THE SOFTWARE TO THE LOCATION

WHERE YOU OBTAINED IT.

Grant of License:

This is a legal agreement between you, the end-user ("You"), and TOSHIBA TEC Corporation ("TTEC").

This software, fonts (including their typefaces) and related documentation ("Software") is licensed for use

with the system CPU on which it was installed ("System") in accordance with the terms contained in this

Agreement. This Software is proprietary to TTEC. TTEC disclaim responsibility for the installation and/or

use of this Software, and for the results obtained by using this Software. You may use one copy of the

Software as installed on a single System, and may not copy the Software for any reason except as

necessary to use the Software on a single System. Any copies of the Software shall be subject to the

conditions of this Agreement. You may not, nor cause or permit any third party to, modify, adapt, merge,

translate, reverse compile, reverse assemble, or reverse engineer the Software. You may not use the

Software, except in accordance with this license. No title to the intellectual property in the Software is

transferred to you and full ownership is retained by TTEC. Source code of the Software is not licensed to

you. You may not perform modification, deletion, etc. about copyright notice of the Software (including in

duplicate).You will be held legally responsible for any copyright infringement, unauthorized transfer,

reproduction or use of the Software or its documentation.

Term:

This license is effective until terminated by TTEC or upon your failure to comply with any term of this

Agreement. Upon termination, you agree to destroy all copies of the Software and its documentation. You

may terminate this license at any time by destroying the Software and its documentation and all copies.

Disclaimer of Warranty:

This Software is provided "AS IS" without warranty of any kind, either express or implied, including, but not

limited to, the implied warranties of merchantability, fitness for a particular purpose, title, and non-

infringement. TTEC disclaim any warranty relating to the quality and performance of the Software. If the

Software proves defective, You (and not TTEC) shall be responsible for the entire cost of all necessary

servicing, repair or correction. TTEC do not warrant that the functions contained in the Software will meet

your requirements or that the operation of the Software will be uninterrupted or error free.

Limitation of Liability:

IN NO EVENT WILL TTEC BE LIABLE TO YOU FOR ANY DAMAGES, WHETHER IN CONTRACT, TORT,

OR OTHERWISE (except personal injury or death resulting from negligence on the part of TTEC),

INCLUDING WITHOUT LIMITATION ANY LOST PROFITS, LOST DATA, LOST SAVINGS OR OTHER

INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY

TO USE THE SOFTWARE, EVEN IF TTEC OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE

POSSIBILITY OF SUCH DAMAGES, NOR FOR THIRD PARTY CLAIMS.

U.S. Government Restricted Rights:

The Software is provided with RESTRICTED RIGHTS. Use, duplication or disclosure by the U.S.

Government is subject to restrictions set forth in subdivision (b) (3) (ii) or (c) (i) (ii) of the Rights in Technical

Data and Computer Software Clause set forth in 252.227-7013, or 52.227-19 (c) (2) of the DOD FAR, as

appropriate. Contractor/Manufacturer is TOSHIBA TEC Corporation, 1-11-1, Osaki, Shinagawa-ku, Tokyo,

141-8562, Japan

End User Software License Agreement