- ページ 6

無線アクセスポイント 3Com WL-548AのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。3Com WL-548A 15 ページ。

3Com WL-548A クイック・インストール・マニュアル

4. Mounting the Sensor

The sensor can be mounted on the following types of surfaces:
Wall, ceiling, or electrical box (NEMA enclosure)
Tabletop

Wall, Ceiling, or Electrical Box Mounting

Use the included mounting bracket to install the sensor on a wall, ceiling, or electrical box.
To wall-mount the sensor:
1
Route Ethernet cable through the opening in the cradle.
2
Screw the mounting bracket to a wall, ceiling, or electrical box (NEMA enclosure):
If mounting to a solid surface wall or ceiling, use the two sheet metal screws.
If mounting to drywall, use the two sheet metal screws and two wall anchors.
If mounting to an electrical box (NEMA enclosure), use the two threaded screws.
The figures below show a cable being routed through the large opening in the cradle and
then the cradle being mounted to a wall.
3
Connect the Ethernet cable (for power and network connection) to the port on the rear of
the sensor.
4
Twist the sensor onto the mounting bracket.
Tabletop Mounting
To install the sensor on a flat surface such as a table or desktop:
1
Remove the backing from the four rubber feet and attach them on the bottom of the sensor.
2
Place the sensor on the table.
3
Connect the Ethernet cable (for power and network connection) to the port on the rear of
the sensor.
Routing a cable
Wall-mounting the cradle
6