- ページ 9

換気フード Whirlpool UXT2030ADのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT2030AD 28 ページ。 30" (76.2 cm) range hood
Whirlpool UXT2030AD にも：取扱説明書 (28 ページ), 取扱説明書 (32 ページ)

ページを印刷する

8. Prepare Range Hood Vents

and Mounting Tabs

Install Strain Relief

■

Install a UL Listed/CSA Approved

strain relief (A).

Mounting Tabs

■

Start a #8-18 x

" (4.2 x 16 mm) truss-head screw into

the mounting tab (D) on each side of the range hood

as shown in the inset. Insert the screws approximately

2 turns into the mounting tab holes.

7" (17.8 cm) Round Vent Installations

■

Remove both top knockouts (B and C).

9. Attach Vent Damper or Transition

7" (17.8 cm) Round Vent Mounting Plate

Using (2) short Phillips head screws, install the 7" (17.8 cm)

■

round vent mounting plate over the vent knockouts

removed in Step 8. Position the wide flange (C) to the front.

NOTE: An optional 7" (17.8 cm) round damper (A),

Part Number W10355451 is available as an accessory.

For information on ordering, see the "Assistance

or Service" section.

If installing the optional round damper, position

■

it over the round vent mounting plate.

" (13 mm)

10. Mount Range Hood

Lift the range hood into place, positioning the rear slots

■

over the mounting brackets.

Using a Phillips screwdriver, push on the screws that

■

are started into the top mounting tabs, and bend the

tabs against the cabinet side walls. Attach the screws

to the cabinet side walls.

IMPORTANT: Do not overtighten the screws.

For direct wire installations, run the home power supply

■

cable according to the National Electric Code or CSA

standards and local codes and ordinances. There must

be enough wiring from the fused disconnect (or circuit

breaker) box to make the connection in the range hood

electrical terminal box.

Tighten the strain relief screws.

■

NOTE: Do not reconnect power until the installation

is complete.

OPTIONAL: If you prefer, bend the rear tabs against

the rear of the range hood and attach to the wall using

#8-18 x

" (4.2 x 16 mm) truss-head screws.

11. Connect Vent System

Connect the ventwork to the range hood.

■

Seal joints with vent clamps or duct tape to make

■

secure and airtight.

Check that the back draft dampers work properly.

■