- ページ 7

換気フード Whirlpool WVU17UC0JWのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WVU17UC0JW 24 ページ。 30" 76.2 cm
Whirlpool WVU17UC0JW にも：取扱説明書 (24 ページ)

ページを印刷する

NOTES:

Depending on your model, determine which venting method

■

to use: roof, wall or non-vented (recirculating).

It is recommended that the vent system be installed before

■

the range hood is installed. Go to "Venting System" in the

"Installation Requirements" section if you need assistance.

Before making cutouts, make sure there is proper clearance

■

within the ceiling or wall for the vent system.

1. Disconnect power

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

2. Mark hole locations

Align the exterior edge of the mounting brackets with the exterior

edges of the upper cabinet.

IMPORTANT: The brackets should touch the upper cabinet.

With a pencil, mark the upper holes on the brackets.

3. Install brackets

INSTALLATION INSTRUCTION

Using a #2 Phillips screwdriver, install the drywall anchors.

■

Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws,

■

install the mounting brackets using the upper holes.

NOTE: For installations to a surface other than drywall, it

is recommended that a qualified contractor determine the

anchoring method.

4. Remove grease filters

Remove the two filter security screws and put them aside.

■

Press the filter latch to release the grease filters.

■

Remove each grease filter.

■

5. Prepare Range Hood

Set the range hood on its back on a covered surface.

■

Using a #2 Phillips screwdriver, remove the rectangular

■

damper attached with 3.5 x 9.5 mm screws.

Using a #2 Phillips screwdriver, remove the electrical box

■

cover.

Using a flat-blade screwdriver, remove the appropriate power

■

supply knockout.