- ページ 8

コントロールユニット ABB MotiFlex e100 OPT-MF-005のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ABB MotiFlex e100 OPT-MF-005 20 ページ。 Digital i/o

4. Confirm that the correct option card is

being installed. The description is

printed on the leading edge of the card,

furthest from the mounting bracket.

Insert the option card with the main

component side facing towards the

center of the drive. The edges of the

option

retaining brackets inside the drive.

5. Push down the option card until it clicks

into place. The option card's external

connector

approximately level with the 8 posts

along the edge of the option slot.

6. Insert the retaining screw and tighten. If

the screw will not locate in the threaded

socket on the option card, then check

the position of the option card.

The screw must be fitted since it

provides mechanical support and an

electrical chassis connection for the

option card.

7. Push on the drive's top or bottom front

panel cover until it clicks into place.

2-2 Introduction

card

should

locate

plate

should

behind

Figure 2-1: Insert the option card

finish

Figure 2-3: Tighten retaining screws

Figure 2-2: Click into place

MN1950WEN