- ページ 7

オール・イン・ワン・プリンター Xerox ColorQube 87 SeriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Xerox ColorQube 87 Series 12 ページ。 Usb card reader configuration guide for workcentre 51 series, workcentre 6400, workcentre 56 series, workcentre 75 series, workcentre 57 series, workcentre 77 series, colorqube 87 series, colorqube 89 series, colorqube 92 series, colorqube 93 series
Xerox ColorQube 87 Series にも：マニュアル (32 ページ)

ページを印刷する

1. Elatec Twn3 Software

Configuring the machine to use USB card reader for

authentication

Create a Device Certificate and Enable SSL

The following configuration settings can only be completed via CWIS.

Note: Either the existing default certificate can be used or the user can install their own certificate. The

steps below use the default certificate.

1. Open a web browser and connect to CWIS by entering the following URL: http://[enter device IP

address]/

2. Click on the [Properties] - [Certificates] – [Security Certificates] (note: SSL must be enabled. If it

is not follow the [Configure SSL] link on this page to enable SSL, then repeat step 2.)

3. Enter System Administrator credentials if prompted

4. On the Xerox Device Certificate tab, click on [Create New Xerox Device Certificate]

5. Select Connection [Enabled] with port 80

6. Select Secure HTTPS [Disabled]

7. Select [Default Xerox Device Certificate]

8. Select Device Certificate : [Default Xerox Device Certificate]

9. Complete all text fill in fields

10. Select the {Subject Alternative Name] checkbox

11. When all entries are complete select [Finish

12. Wait while the new certificate is created.]

13. Select [Apply]

Configure the feature via the existing Xerox Secure Access web page

1. Navigate to [Security] - [Authentication] – [Setup]

2. Select [Xerox Secure Access Unified ID System] as the Authentication method on the machine's

touch user interface

3. Under Configuration Setting, select the [Edit] button next to [Xerox Secure Access Setup]

4. Normally the configuration settings are pushed down from the partner server. If you plan to use this

method, select [Close] and consult the particular solution partner's installation and configuration

documentation. If you wish to configure these settings manually, select [Manually Configure]

5. Fill in the server Communication details using either IP address or Host Name. Include the path to

the server.

6. Verify that the [Embedded] box is NOT checked. This checkbox enables software which only works

with the white egg shaped Xerox Secure Access card readers.

7. Set the [USB Card Reader Detection Policy] to either allow or deny access to the MFP if the card

reader becomes unplugged. This will cause a Caution screen to appear whenever the card reader is

accidentally unplugged and remind the user to plug it back in.

8. Set the [Device Log In Method] to either enable only swipe card authentication or whether to also

offer Alternate Authentication where the user manually enters their logon credentials in the event they

lost or forgot their card.

USB Card Reader Configuration Guide