- ページ 9

プリントサーバー Xerox DOCUCOLOR 12のPDF マニュアルを知るをオンラインで閲覧またはダウンロードできます。Xerox DOCUCOLOR 12 24 ページ。 Carrier
Xerox DOCUCOLOR 12 にも：仕様 (2 ページ), リファレンス・マニュアル (10 ページ), クイック・スタート・マニュアル (5 ページ), クイック・スタート・マニュアル (8 ページ), マニュアルの使用 (12 ページ), 補足マニュアル (4 ページ), 補足マニュアル (18 ページ)

Performing routine tasks

Loading paper in tray 1

Demonstrate the steps as you describe them. See

Figure 6.

You have four paper trays. To load paper in tray 1:

Note: Tray 1 is preset to hold up to 500 sheets of 8.5

x 11 in. paper. The tray can be set to hold A4 paper

by your service representative.

1. Face the DocuColor 12 Printer so that you are

directly in front of the paper trays.

2. Open the tray by pulling it straight out.

3. Take the paper out of the wrapper.

4. Place the stack of paper in the drawer as shown.

Add paper up to the Max line. Straighten the

paper stack so the edges are even.

5. Close the tray by pushing it in toward the

printer.

Note: Paper trays 2, 3, and 4 can hold up to 550

sheets of paper. Sizes can be adjusted from 8 x 10 to

11 x 17 in..

To load paper in trays 2, 3, or 4: (See Figure 7)

1. Open the tray by pulling it straight out.

2. Place paper in the tray, pushing the paper all the

way to the left. Straighten the stack so the edges

are even.

3. Adjust the rear paper guide by squeezing the

release and sliding the paper guide toward the

front of the printer until it just touches the stack

of paper.

4. Adjust the right paper guide by squeezing the

release and sliding the paper guide to the left

until it just touches the stack of paper.

5. Close the tray by pushing it in toward the

printer.

Getting to Know Your Product

Product Orientation Guide

Figure 6

Figure 7