- ページ 10

ホブ Zanussi PW64のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Zanussi PW64 11 ページ。 Gas hob pn 64; ps 64; pw 64; px 64; ptdf 64
Zanussi PW64 にも：取扱説明書 (13 ページ)

Electrical connections

Any electrical work required to install this appliance

should be carried out by a qualified electrician or

competent person, in accordance with the current

regulations.

THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should these

safety measures not be observed.

This appliance is designed to be connected to a

230 V 50 Hz AC electrical supply.

Before the appliance is connected:

1) check that the main fuse and the domestic installation

can support the load (see the rating label);

2) check that the power supply is properly earthed in

compliance with the current rules;

3) check the socket or the double pole switch used for

the electrical connection can be easily reached with

the appliance built in the forniture unit. Before

switching on, make sure the electricity supply voltage

is the same as that indicated on the appliance rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this

book.

The appliance is supplied with a 3 core flexible supply

cord incorporating a plug. Connect the plug to an adequate

socket.

Permanent Connection

In the case of a permanent connection, it is necessary

that you install a double pole switch between the

appliance and the electricity supply (mains), with a

minimum gap of 3 mm between the switch contacts and

of a type suitable for the required load in compliance

with the current electric regulations.

The switch must not break the yellow and green earth

cable at any point and it should be 2-3 cm longer than

the other cables.

Ensure that the hob supply cord does not come

into contact with surfaces with temperatures

higher than 50 deg. C.