- ページ 6

冷凍庫 Zanussi ZFC631WAPのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZFC631WAP 8 ページ。 Chest
Zanussi ZFC631WAP にも：ユーザーマニュアル (12 ページ), ユーザーマニュアル (12 ページ)

ページを印刷する

Ventilation requirements

1. Put the freezer in horizontal position on a firm surface.

The cabinet must be on all four feet.

2. Make sure that the clearance between the appliance

and rear wall is 5 cm.

3. Make sure that the clearance between the appliance

and the sides is 5 cm.

The airflow behind the appliance must be sufficient.

Electrical Connection

Caution! Any electrical work required to install this

appliance should be carried out by a qualified

electrician or competent person.

Warning! This appliance must be earthed.

The manufacturer declines any liability should these

safety measures not be observed.

Environmental concerns

The symbol

on the product or on its packaging

indicates that this product may not be treated as

household waste. Instead it should be taken to the

appropriate collection point for the recycling of electrical

and electronic equipment. By ensuring this product is

disposed of correctly, you will help prevent potential

Important! The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow:

Brown:

Blue:

As the colours of the wires in the mains lead of this ap-

pliance may not correspond with the coloured markings

identifying the terminals in your plug, proceed as follows:

1. Connect the wire coloured green and yellow to the

terminal marked either with the letter "E" or by the

earth symbol

or coloured green and yellow.

2. Connect the wire coloured blue to the terminal either

marked with the letter "N" or coloured black.

3. Connect the wire coloured brown to the terminal ei-

ther marked with the "L" or coloured red.

4. Check that no cut, or stray strands of wire is present

and the cord clamp

sheath.

5. Make sure the electricity supply voltage is the same

as that indicated on the appliance rating plate.

6. Switch on the appliance.

The appliance is supplied with a 13 amp plug fitted

In the event of having to change the fuse in the plug sup-

plied, a 13 amp ASTA approved (BS 1362) fuse must be

used.

Warning! A cut off plug inserted into a 13 amp

socket is a serious safety (shock) hazard. Ensure

that it is disposed of safely.

negative consequences for the environment and human

health, which could otherwise be caused by inappropriate

waste handling of this product. For more detailed

information about recycling of this product, please

contact your local council, your household waste disposal

service or the shop where you purchased the product.

Earth

Live

Neutral

is secure over the outer