- ページ 10
冷凍庫 Zanussi ZFT11112WEのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZFT11112WE 16 ページ。
ページを印刷する
Problem
Door is misaligned or interferes
with ventilation grill.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
10
Possible cause
Food products are not wrapped
properly.
Temperature is set incorrectly.
The appliance is not levelled.
The temperature regulator is not
set correctly.
The food products' temperature
is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
Wrap the food products better.
Refer to "Operation" chapter.
Refer to "Levelling".
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Defrost the appliance.
Make sure that there is cold air
circulation in the appliance.
"Installation".
gaskets. Contact the After Sales Service.
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Service Centre
Solution
www.zanussi.com