- ページ 11
調理器 Zanussi ZCG560GのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZCG560G 20 ページ。 Zanussi zcg560g cooker user manual
Zanussi ZCG560G にも： ユーザーマニュアル (20 ページ)
ページを印刷する
Removing the oven door and the glass panel
1
Open the door fully
and hold the two door
hinges.
3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove it from
its seat.
What to do if...
Problem
The flame is blown out immediately
after ignition.
The gas ring burns unevenly.
The oven does not heat up.
www.zanussi.com
2
Lift and turn the levers
on the two hinges.
1
1
4
Place the door on a
stable surface protected by
a soft cloth.
Use a screwdriver to re-
move 2 screws from the
bottom edge of the door.
Important! Do not lose the
screws.
.
Possible cause
The thermocouple is not heated suffi-
ciently.
The burner crown is blocked with
food residue.
The oven is not activated.
3
2
2
5
Use a spatula made of
wood or plastic or equiva-
lent to open the inner
door.
Hold the outer door, and
push the inner door
against the top edge of the
door.
Warning! Only clean the glass panel with water and
a soap. Abrasive cleaning agents, stain removers
and sharp objects (e.g. knives or scrapers) can cause
damage to the glass.
Inserting the door and the glass panel
When the cleaning procedure is completed, insert the
oven door. To do so, do the steps in opposite way.
4
4
6
5
5
After lightning the flame, keep the
knob pushed for approximately 10
seconds.
Make sure that the injector is not
blocked and the burner crown is clear
of food particles.
Activate the appliance.
6
Lift the inner door.
7
Clean inner side of the
door.
Clean the glass panel with
water and soap. Dry it
carefully.
Remedy
11