- ページ 8

コントロールユニット Alemite 3621-BのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Alemite 3621-B 11 ページ。 Electronic-metered control valve

ページを印刷する

SER 3620

Assembly

NOTE: Prior to assembly, certain compo-

nents require lubrication. Refer to Table 2

for details.

Control Valve Handle

NOTE: Refer to Figure 6 for a section

view of the control valve handle assembly.

1. Install Roll Pin (31) into Body (30) as required.

IMPORTANT: Lubricate O-Rings (42)

with grease prior to installation.

2. Install O-Rings (42) onto Cam (43).

3. Install the Cam assembly into the Body.

• Make sure to orient the Cam as shown in Figure 5.

4. Position Lever Assembly (40) onto the tabs of the

Cam.

• Make sure the safety does not interfere with the

Body.

5. Install Screws (41) that secure the Lever Assembly

to the Cam.

• Tighten the Screws securely.

6. Install Seal (33) [blunt end first] onto Push Rod (32).

7. Install Spring Support (35) into the small end of

Compression Spring (36).

8. Install Small Compression Spring (34) onto the

Spring Support.

9. Install the Push Rod and Seal assembly onto the

Spring Support.

10. Install the Compression Spring (with assembled

components) into the Body.

• Make sure the Push Rod seats properly on the

Cam.

11. Install Strainer (37) into the Compression Spring.

12. Install O-Ring (38) onto Swivel Assembly (39).

Item No.

O-Ring, 1/2 " ID x 5/8 " OD

O-Ring, 1/2 " ID x 11/16 " OD

Revision (11-05)

1-800-548-1191-http://[email protected]

13. Screw the Swivel Assembly into the Body.

Description

Clean Oil

Multi-Purpose Grease

Table 2 Lubricated Components

Electronic-Metered Control Valve

NOTE: Swivel Assembly is under Spring pres-

sure during installation.

• Tighten the Swivel Assembly securely.

Transmission Fluid Filter

NOTE: Refer to Figure 5 for component iden-

tification.

1. Install Filter Tube (26) into Body (25).

2. Install O-Ring (28) onto Spring and Adapter Assembly

(29).

3. Install the small button of Stud (27) into the spring of the

Spring and Adapter Assembly.

4. Screw the Spring and Adapter Assembly into the Body.

• Tighten the Spring and Adapter Assembly securely.

Non-Drip Nozzle (Automatic w/ Manual Lock)

NOTE: Refer to Figure 3 for component iden-

tification.

1. Install Gasket (22) into Angle Body (21).

2. Install Washer (23) into Screw Assembly (24).

3. Thread the Screw Assembly into the Angle Body.

• Tighten the Screw Assembly securely.

4. Install O-Ring (17) onto Nozzle (16).

5. Install and seat V-Block (18) [concave first] onto the

pointed end of Stem (19).

6. Install the Stem assembly [point first] into the Nozzle.

7. Install Spring (20) into the Stem.

8. Screw the Nozzle assembly into Angle Body.

• Tighten the Nozzle securely.

Item No.

O-Ring, 3/4 " ID x 15/16 " OD

O-Ring, 13/16 " ID x 1 " OD

Description

Alemite LLC