電動工具 ARO 8133のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ARO 8133 8 ページ。
ARO@
OPERATOR'S
MANUAL
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
Form 49999-055
50 SERIES POWER UNIT
Model 8133
3200 R.P.M.
Edition 3
April 2000
10589471
WARNING
READ THIS MANUAL
CAREFULLY
BEFORE INSTALLING,
OPERATING
OR SERVICING
THIS EQUIPMENT.
FAILURE TO OBSERVE
THE FOLLOWING
WARNINGS
COULD RESULT IN INJURY.
Pneumatic tools should always be installed and used in accor-
dance with A.N.S.I. 8186.1 "Safety Code For Portable Air Tools."
Operate this motor at 90 p.s.i.g. (6.2 bar) maximum air pres-
sure at the air inlet of the motor.
Disconnect air supply from motor before removing/installing
bit, socket or device attached to motor or performing mainte-
nance procedures.
Keep hands, clothing and long hair away from rotating end of
motor.
Anticipate and be alert for sudden changes in motion during
start up and operation of any power motor.
Never exceed rated r.p.m. of motor.
Wear suitable eye and hearing protection while operating mo-
tor.
Motor shaft can continue to rotate briefly after throttle is re-
leased.
Do not lubricate motor with flammable or volatile liquids such
as kerosene, diesel or jet fuel.
Do not remove any labels. Replace any damaged label.
Use only accessories
recommended
by ARO.
Repeated prolonged operator exposure to vibrations which may
be generated in the use of certain hand-held motors may produce
Raynaud's
phenomenon,
commonly
referred to as Whitefinger
disease.
The phenomenon
produces
numbness
and burning
sensations
in the hand and may cause circulation and nerve dam-
age as well as tissue necrosis. Repetitive users of hand-held mo-
tors who experience vibrations should closely monitor duration of
use and their physical condition.
l
The use of other than genuine AR0 replacement
parts may
result in safety hazards, decreased
motor performance
and
increased maintenance
and may invalidate all warranties.
l
AR0 is not responsible for customer modification of motors for
applications
on which AR0 was not consulted.
l
Motor maintenance and repair should be performed by autho-
rized, trained, competent
personnel.
Consult your nearest
AR0 authorized servicenter.
l
It is the responsibility
of the employer to place the information
in this manual into the hands of the operator.
For parts and service information, contact your local AR0 distributor, or the Customer Service Dept. of the Ingersoll-Rand
Distribution
Center, White House, TN at PH: (615) 672-0321,
FAX: (615) 672-0801.
AR0 Tool Products
AR0
Ingersoll-Rand
Company
1725 U.S. No. 1 North 0 P.O. Box 8000 0 Southern Pines, NC 2838843000
©2000
Ingersoll-Rand
Company.
PRINTED
IN U.S.A.