- ページ 13

3Dプリンター 3D Upfitters LulzBot Mini 2 R1のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。3D Upfitters LulzBot Mini 2 R1 18 ページ。 Enclosure kit

8. Attach Right Side

By this point all of the corner connectors have been attached, so what remains is

simply to use M4 12mm screws to attach the right-side's four corners and three mid-

corner connectors. When attaching the screw to the top mid-panel connector, be sure

to not push out the nut held on with glue.

9. Seal Gaps

Once the enclosure is completely put together, it's time to make sure that each of the

panels is held tightly to each adjoining panel. The connectors are designed with a

small amount of play that allows you to make small adjustments for the perfect ﬁt.

1. Loosen screws on the panel to move.

2. Push that panel into place. You may need a friend to hold it there.