- ページ 10

MP3プレーヤー DJ-Tech uSolo ProのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DJ-Tech uSolo Pro 12 ページ。 Professional usb

OPERATION INSTRUCTION

10. TIME DISPLAY

During normal play, each time you press TIME button, the display information changes between time

elapsed and time remain.

11. PITCH BENDING

There are 2 ways to pitch bend the playing song:

(1) The speed increases or decreases respectively while the PITCH BEND "+" or PITCH BEND "-" button is

pressed. The pitch changes within the range of +/- pitch selected.

(2) Turning the jog wheel will temporarily bend the pitch of the music, turning the wheel clockwise to speed

up or counterclockwise to slowdown.

12. AUTO LOOP

Hold the TIME button for 1 second to turn on/off AUTO LOOP mode. A green LED will glow in the BEAT

LEDs part. Hold TIME button and press the BEAT-SYNC Button to change the AUTO LOOP BEAT division

among 1/16, 1/8, 1/4, 1/2, 1, 2/1.

In Auto Loop mode, press IN to activate the auto loop and press OUT to quit the auto loop.

Note: As the AUTO LOOP function depends on the BPM detection. Normally, the AUTO BPM detection

takes a few seconds to detect the BPM for the song. So, when a new song is selected, the AUTO LOOP

cannot be activated until a BPM value is detected or manually set.

13. BPM SYNC EFFECT

There are 8 BPM SYNC effects (FXs) in this unit. Multiple FXs can be activated at the same time. Among the

FXs, there are some mutually exclusive pairs, which means that you can only turn on one FX in these pair at

the same time. They are SCRATCH and SKID, FILTER and PHASE, ECHO and FLANGER, and TRANS

and PAN. For example, when SCTARCH FX is on, pressing the SKID button will activate SKID FX and

deactivate SCTARCH FX.

These 8 FXs are BPM SYNC. Press the BEAT-SYNC SELECT BUTTONS to adjust the Time parameter of

the FX to be

synchronized

14. RELAY PLAY USING TWO PLAYERS

How to set the Relay function:

When the both players' RELAY jacks are connected to each other, the relay-play FX can be produced. The

relay play is explained as below.

Set both players to single play mode (the SINGLE indicators will light in the displays).

Begin playback on the first player.

When the currently playing track ends, playback will begin automatically on the standby player.

The first player will enter pause mode at the beginning of the next track.

By repeating this operation, the two players can be used to perform continuous relay play.

Note: Relay play may not work properly if the audios out jacks on the two players are not connected to the

same audio amplifier.

15. STUTTER EFFECT

It can create a sound similar to a CD skipping. The STUTTER Effect can be created in 2 ways.

(1) By rapidly pressing the CUE button

a. Press PLAY/PAUSE button so that music is playing. PLAY/PAUSE LED will light.

b. Next, rapidly press the CUE button in sync with the music.

(2) By rapidly pressing the BANK1 or BANK 2 or BANK 3 or BANK 4 buttons.

with the BPM.