- ページ 7

DJ機材 djpower djV PRO STAGE EFFECTS DC-1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。djpower djV PRO STAGE EFFECTS DC-1 11 ページ。 C02 confetti blaster

4.5

DMX Linking

You can link the DC-1 to a DMX controller using a 3- or 5- pin DMX connection. If using other DMX-compatible products with this

product, you can control each individually with a single DMX controller. Instructions for connecting and configuring this product for

DMX operation are in the User Manual.

4.6

Mounting

Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes.

4.6.1

Orientation

For safety reasons, we do not recommend mounting the product in any capacity. Operate the product while it is on the ground

only, and make sure there is adequate room for ventilation, configuration, and maintenance.

4.6.2

Rigging

DJPOWER recommends using the following general guidelines when mounting this product.

•

Before deciding on a location for the product, make sure there is easy access to the product for maintenance and programming

purposes.

•

Make sure that the structure or surface onto which you are mounting the product can support the product's weight (see the

Technical Specifications).

•

When mounting the product on the floor, make sure that the product and cables are away from people and vehicles.

OPERATION

5.1

Preparing for Operation

•

After checking that all the parts are intact and complete, position the machine on flat.

•

Unlock and remove the top cover, and take out the woofer

•

Lock the woofer firmly onto the bayonet socket of the hopper until it locks in place.

•

Before connecting to the machine, make sure you connect CO2 cylinder correctly.

*The order of connection: others connector should be connected well before connecting CO2 quick connector.

* Place an 20 cm object underneath the CO2 cylinder while place it horizontally, and its bottom must higher than the top (refer

to the picture as below).

•

Always connect the product to a grounded circuit. Before power on, make sure if it is connected with the rated voltage.

•

Wind and other weather circumstances will influence the output height and output distance of the confetti.