- ページ 6

計測機器 Akron 3462のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Akron 3462 17 ページ。 Forestry bumper monitor
Akron 3462 にも：設置、操作、メンテナンスに関する説明書 (18 ページ)

ページを印刷する

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS

Remove gearbox housing (19) from the motor assembly (15).

Replace o-ring seal (18) on the gearbox housing (19).

Attach the new motor assembly (15) to the gearbox housing (19) making sure all four screws (21) are tight.

Install the motor and the gearbox housing assembly to the unit making sure all four socket screws (49) are tight. It

may be necessary to rotate the motor slightly to get the motor gear to line up with the gears inside the gearbox.

Restore power to the unit.

10. Test the operation of the unit.

Call Akron Brass Customer Service Department if any problems are encountered.

TABLE 1

Symptom

Potential Cause

Totally Inoperative

Lack of Power

Damaged Control Box

No CAN Communication

PHONE: 800.228.1161 | WEBSITE: www.akronbrass.com

Sheet: 122386

STYLE 3462 FORESTRY BUMPER MONITOR

What to Check

Remove the Power/Valve Cable connector from

the control box mounted on the side of the

monitor/turret. Check for voltage approximately

equal to vehicle battery voltage between pins 1

(Pos.) and 2 (Neg.) of the cable's connector.

Remove the CAN Cable connector from the

control box mounted on the side of the

monitor/turret. Check for voltage approximately

equal to vehicle battery voltage between pins 1

(Pos.) and 2 (Neg.) of the control box connector.

Insert an empty USB Flash Drive (with a status

LED) into the USB connector. Check for lighting of

the Flash Drive status LED.

Check status LED's located near the Joystick

connector for power and CAN activity.

Revision 12/2022

Solution

If no measurable voltage is present, insure proper

DC power is applied to pins 1 and 2.

If no measurable voltage is present, return the

Control Box/Harness for replacement.

If the Flash Drive status LED does not light, return

the Control Box/Harness for replacement.

If no status LED's are lit, check CAN cable continuity

end to end (1 to 1, 2 to 2, etc.), and retest.

If only Power status LED is lit, return the Joystick for

replacement.

If only Power and Transmit LED's are lit, return the

Control Box/Harness for replacement.

Page: 6 of 17