- ページ 5

トラック BlueRange TRUCK680のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。BlueRange TRUCK680 8 ページ。 Hydraulic hand pallet truck

3. TO ADJUST RELEASE DEVICE

The control handle (A117) is located in at the top of the Draw Bar handle, it has three positions:

Lower position - RAISE the pallet forks when pumped.

Middle Position: DRIVE position – no movement of the forks when pumped.

Top Position: Lowers the pallet forks when handle is lifted, springs back to centre position when

released.

If however they have been changed, you can adjust according to following step:

3.1 If the forks elevate while pumping in the DRIVE position, turn the adjusting nut (A104) on the

adjusting bolt(A103) or screw(A318) clockwise until pumping action does not raise the forks and

the DRIVE position functions properly.

3.2 If the forks descend while pumping in the DRIVE position, turn the nut(A104) or screw(A318)

counter-clockwise until the forks do not lower.

3.3 If the forks do not descent when the control handle (A117) is in the LOWER position, turn the

nut(A104) or screw (A318) clockwise until raising the control handle(117) lowers the forks. Then

check the DRIVE position according to item 3.1 and 3.2 to be sure the nut (A104) and screw( A318)

is in the proper position.

3.4 if the forks do not elevate while pumping in the RAISE position, turn the nut (A104) or screw

(A318) counter-clockwise until the forks elevate while pumping in the RAISE position. Than check

the LOWER and DRIVE position according to item 3.1, 3.2 and item 3.3.

4. MAINTENANCE

The pallet truck is largely maintenance-free.

4.1 OIL

Please check the oil level every six months. The oil can be hydraulic oil: ISO VG32, its viscosity

should be 30cSt at 400 C, total volume is about 0.41t.

4.2 TO BLEED THE HYDRAULICS

The air may come trapped in the hydraulic oil because of transportation of the pump in a upturned

position. It can cause that the forks not to elevate while pumping in the RAISE position. The air can

been removed in the following way: hold the control handle (A117) on the LOWER position, then

move the draw-bar up and down for several times.

4.3 DAILY CHECK AND MAINTENANCE

Daily check of the pallet truck can limit wear as much as possible. Special attention should be paid

to the wheels, the axles, as thread, rags, etc, may jam the wheels. The forks should be unloaded and

lowered to the lowest position when the checks are completed.

4.4 LUBRICATION

All bearings and shafts are fitted with long-life grease at the factory. Grease points should be

checked and topped up if necessary every month with long-life grease, or when the bearings have

been overhauled.

Page 5