- ページ 13

食器洗い機 Asko D3251HDSSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Asko D3251HDSS 16 ページ。 Asko d3251hdss: user guide
Asko D3251HDSS にも：クイック・スタート・マニュアル (2 ページ)

ページを印刷する

FREQ

UENTL

Y ENCOUNTERED SITU

Y ENCOUNTERED SITUA A A A A TIONS

FREQ

FREQUENTL

UENTL

UENTLY ENCOUNTERED SITU

Y ENCOUNTERED SITU

Detergent left in compartment

♦ Be careful not to load items so close to the dispenser

that the cover will not open to release the detergent.

♦ The dispenser is not supposed to open when you

use the Rinse program.

♦ Your dishwasher detergent should be fresh and

stored tightly closed in a cool, dry place. Old or caked

detergent should be thrown away because it will not

dissolve properly and will leave a gritty residue on

the dishware.

♦ Wait until you are ready to start the dishwasher to

add the detergent.

♦ If you are using the Delay program, make sure the

dispenser is dry before adding the detergent.

♦ The detergent compartment only opens in the main

wash programs, not the Rinse program.

Dishwasher makes unusual noises

♦ This usually means that something is not loaded

properly. Make sure the dishes are securely in place

and that nothing has fallen between the basket tines.

Also, place small items in the small items

compartment and close the lid. (See page 4.)

Dishwasher leaks

♦ Use only unscented, granular automatic dishwasher

detergent. Using a liquid detergent could cause

oversudsing and leakage.

♦ You should always use fresh detergent.

♦ The amount of detergent needed for your dishes

depends on the hardness of the water in your area.

Contact your local utility company to learn the water

hardness in your area then refer to the chart on page

5 to determine the amount of detergent you should

use.

♦ Be careful not to overfill the rinse aid dispenser.

Spilled rinse aid could cause oversudsing and lead

to overflowing. Wipe away any spills with a damp

cloth.

♦ Make sure the dishwasher is level. (See the

installation instructions.)

Dishwasher runs too long

♦ If the temperature of the water entering your dishwasher

is below 120°, the dishwasher runs longer because it

heats the water to the proper temperature for the

program selected. Raising your water heater setting

may help to shorten the cycle times. If this doesn't

resolve the problem, call the ASKO Advisory Center.

TIONS

Dishwasher does not drain properly

♦ Make sure that the cycle was complete before you

opened the dishwasher. If not, allow it to complete

and check again.

♦ Some water left in the sump area near the drain is

normal.

♦ If the plumbing code in your area requires an air

gap, make sure that the air gap isn't blocked or

plugged.

♦ If the unit is connected to a garbage disposer, make

sure the disposer is empty.

♦ If water backs up into the sink, check the garbage

disposer and trap for blockage.

♦ Check the dishwasher filters and drain area for

blockage. (See page 10.)

♦ Check for a kink in the drain hose.

Dishwasher does not fill properly

♦ Make sure the water supply is turned on.

♦ Make sure the dishwasher is turned on and the door

is closed securely.

♦ Check for crimps in the water feed line.

♦ The system is designed to detect an overflow. When

it does, it shuts off the inlet valve and circulation pump

and turns on the drain pump. (See "Overfill

Protection" on page 11.)

Dishwasher will not start

♦ Make sure the dishwasher is turned on and the door

is closed securely.

♦ Make sure the Delay option is not turned on.

♦ Check that the water supply is connected properly

and the water is turned on.

♦ Make sure the power cord is properly plugged into

the wall socket.

♦ Check your fuse box for a blown fuse or tripped circuit

breaker.

Bad odour in the machine

♦ The low temperature programs have been selected

over a longer period of time.

♦ Run a program at Normal temperature about once

per month.

Customer Care Center

1-800-898-1879

www. askousa.com

Page 13