- ページ 11

食器洗い機 Asko D5223XXLCSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Asko D5223XXLCS 16 ページ。 Xxl dishwasher
Asko D5223XXLCS にも：プランニング・デザイン・マニュアル (3 ページ)

CONNECTING THE WATER SUPPLY

In order to prevent heat damage to the inlet valve, all

solder connections must be made before the water supply

line is connected.

Flush the water supply line prior to connecting it to the

water fill tube.

The unit has a float switch in the base pan to protect

against flooding. If the inlet valve connection is not seated

properly, water may leak into the base pan and activate

the float switch.

It is important that the water supply line and the shut-off

valve have a sufficient flow volume. At last 3 gallons (12

liters) per minute must be able to pass through the line.

The water pressure should be 4.2-140 psi.

(1)

Water supply

(2)

Water supply valve (not supplied)

NOTE:

Be sure to run the PEX tubing through the hole to sink

compartment before moving the dishwasher into posi-

tion.

1. Turn on the water supply and check for leaks.

2. Turn the power on at breaker/fuse box and test the

dishwasher operation by running a Rinse cycle. (This

should take about four minutes.)

3. Turn off the electrical power and check for leaks under

the dishwasher and sink.

4. Make sure that no kinks have developed in the drain

lines.

If there are no leaks and the dishwasher seems to be

working properly, continue with the installation.

Customer Care Center

1-800-898-1879

www.askousa.com

Page 11