Asko W6441 사용 및 관리 매뉴얼 - 페이지 14

{카테고리_이름} Asko W6441에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko W6441 20 페이지. User manual use & care guide fr
Asko W6441에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 기획 및 디자인 매뉴얼 (19 페이지), 서비스 매뉴얼 부록 (10 페이지), (스페인어) 사용 및 관리 가이드 (20 페이지), (프랑스어) Manuel D'utilisation Et D'entretien (20 페이지)

페이지 인쇄

TROUBLESHOO

OUBLESHOOTING

OUBLESHOO

Extr

Extreme vibr

Extr

eme vibra a a a a tion during spin c

eme vibr

tion during spin c

tion during spin cy y y y y c c c c c le le le le le. . . . .

Extr

eme vibr

tion during spin c

♦ Make sure the packaging and shipping supports were

removed properly. (See page 4.)

♦ Check that the machine is level.

♦ Adjust machine feet and tighten locknuts. (See page 4.)

Over

ersudsing

sudsing. . . . .

sudsing

♦ Too much detergent could cause suds to back up

through the detergent compartment and run down

the front of the washer onto the floor. The suds will

condensate into water and form a small puddle on the

floor. (See page 8 for detergent recommendations.)

W W W W W asher stops during c

asher stops during c

asher stops during cy y y y y c c c c c le le le le le. . . . .

asher stops during c

♦ It is normal for the machine to pause occasionally

during operation, especially between cycles and

during the delicate wash program.

♦ Make sure the No Spin option isn't turned on.

♦ If the power switch is on and the indicator lamp is

not lit, there is no power supply. Make sure the

machine is properly plugged into the electrical outlet.

♦ Check the house breaker switch/fuses.

F F F F F oam in the f

oam in the f

oam in the final rinse w

oam in the f

inal rinse wa a a a a ter

inal rinse w

oam in the f

inal rinse w

♦ Make sure nothing is blocking the outlet hose.

♦ Check for kinks in the outlet hose.

♦ Make sure the pin trap isn't blocked. (See page 12.)

♦ Make sure that no part of the hose (including any

joints) is less than 3/4" (19 mm) in diameter.

ERR

OR MESSA

GES

ERR

ERROR MESSA

ERR

OR MESSAGES

OR MESSA

GES

Error messages will display on the LED if faults occur

while a program is in progress. The table below defines

each possible error message.

MESSAGE

MESSA

ERR

ERROR

ERR

MESSA

ERR

When this symbol flashes on the LED it merely means the glass door isn't closed securely.

Close the door and try again.

0000

If this message flashes on the LED, the machine has failed to spin. This could be because the

load is out of balance. Turn the power off then on again. Open the door and redistribute the

washing. Run the Spin program again.

This indicates an overflow has occurred. Call a service technician.

This indicates a problem with the motor. Call a service technician.

This indicates a problem with the drain pump. Refer to the Troubleshooting chapter for possible

solutions.

This indicates a problem with the water inlet. Refer to the Troubleshooting chapter for possible

solutions.

This indicates a problem with the thermistor. Call a service technician.

This indicates a temperature stop fault. Call a service technician.

This indicates foaming. Run the Rinse program again. Try using less detergent and softener

and use only low-sudsing detergents. (See page 8.)

This indicates a door opening fault. Call a service technician.

Page 14

TING

(CONTINUED)

ter. . . . .

ter

W W W W W a a a a a ter left in the mac

ter left in the mac

ter left in the machine after f

ter left in the mac

spin.

♦ Make sure the No Spin option isn't turned on.

♦ Make sure the pin trap isn't clogged. (See page 12.)

♦ Make sure the outlet hose isn't clogged.

♦ Check for kinks in the outlet hose.

♦ Make sure that no part of the outlet hose (including

any joints) is less than 3/4" (19 mm) in diameter.

W W W W W a a a a a ter leaks

ter leaks

ter leaks. . . . .

ter leaks

♦ All hoses should be inspected at least once a year.

If they show signs of cracking, they should be

replaced.

♦ Check to see if hose connections at faucets are tight.

♦ Make sure the end of the outlet hose is securely

inserted into the drain receptacle.

♦ Make sure nothing is caught between the Smart Seal

and the tank, such as apron strings, small

handkerchiefs, socks, etc.

To remove the message, turn the power off or change

the program.

hine after final

hine after f

inal

hine after f

inal