Askoll PURE XL HC LED 사용 설명서 - 페이지 6

{카테고리_이름} Askoll PURE XL HC LED에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Askoll PURE XL HC LED 14 페이지. Marine aquarium kit
Askoll PURE XL HC LED에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지)

페이지 인쇄
Askoll PURE XL HC LED 사용 설명서
3.3. Technical data
Description
Capacity
Imp gal
Product weight
Maximum
allowed
weight of the aquar-
ium
Height
Width
Depth
Water temperature
(min. / max.)
PUMP / LIGHTING UNIT / THERMAL HEATER
Power supply
V / Hz
Consumption
IP protection rating

4. PREPARING THE PRODUCT FOR USE

4.1. Unpacking
The product has glass components.
Handle with care and place it according to the instruc-
tions of this manual avoiding to lean the tank directly
on the edges.
1) Open the carton's top flaps and remove the polystyrene sheet.
2) Extract the product as indicated on the packaging itself. Always
handle it with care.
3) Place it on a flat, smooth and clean surface; take care not to
scratch or damage the glass tank bottom.
4) Remove the transparent film on the covers and upper frame.
5) Remove the lighting and filter covers from the frame (fig. 3) and
3
PURE
PURE
PURE
M LED
L LED
XL LED
L
44
68
94
9,68
14,96
20,68
kg
8,8
14,1
19,2
kg
75
120
165
cm
43,5
43,5
43,5
cm
36
56
76
cm
36
36
36
°C
from +5 to +35
See data provided on the individ-
W
ual electric devices making up the
product.
WARNING
4
EN
place them on a flat, clean surface without scratching them.
6) Remove the pump unit (fig. 4) and place it on a flat surface.
7) Remove the frame from the tank (fig. 5) and place it on a flat,
PURE
clean surface without scratching it.
XL HC
8) Carefully remove the thermal heater and led driver from their
LED
packaging inside the tank, along with the cable guide.
130
9) Dispose of the packaging material in observance of local reg-
28,6
ulations.
10) Check that the product has all the components indicated in par.
28,3
3.2.
215
4.2. Positioning
57
The product must be positioned with care, in observance of the fol-
lowing instructions:
76
36
To avoid instability risk: check with a level that the sup-
port surface of the product is horizontal.
Do not lean the product on inclined surfaces.
It is advisable to place the product on the foreseen
aquarium stand. Alternatively, use a sturdy support
able to bear the maximum allowed weight of the aquar-
ium (see technical data par. 3.3). Such support must
have a levelled, smooth and clean support surface.
In order not to ease algae proliferation: place the
product far from heat sources and direct exposure to
sunlight.
1) Position the product so that the wording "FRONT" is at the front
and at a distance from the power outlet which enables each
electrical equipment cable to have a drip loop.
2) Remove the "FRONT" label and dispose of it as required by local
regulations.
WARNING
CAUTION
5
7