ASKOMA ASKOHEAT-F+ AHFR-BI-plus-3.5 피팅 지침, 사용자 설명서 및 서비스 - 페이지 3

{카테고리_이름} ASKOMA ASKOHEAT-F+ AHFR-BI-plus-3.5에 대한 피팅 지침, 사용자 설명서 및 서비스을 온라인으로 검색하거나 PDF를 다운로드하세요. ASKOMA ASKOHEAT-F+ AHFR-BI-plus-3.5 10 페이지.

ASKOHEAT

Flange heater Ø 180mm

-F+

Operating instructions

I m p o r t a n t i n f o r m a t i o n

If a heat exchanger is fitted in the same tank, the controller must limit the temperature caused by the

heat exchanger to 85°C. This prevents the safety temperature limiter of the flange heater tripping.

S a f e t y t e m p e r a t u r e l i m i t e r

The safety temperature limiter may trip at temperatures lower than approx. –15°C (e. g. transportation

or storage). If this happens, press the reset button, see page 6 "user manual".

T h e d e v i c e m a y o n l y b e u s e d t o h e a t w a t e r.

C o r r o s i o n p r o t e c t i o n

Please note: This heating element is applicable in stainless steel boiler as well as in black steel / black

steel enamelled boilers. Select the settings via DIP switch according to the boiler type.

For an installation of the heating element into black steel or black steel enamelled boilers, the red slide

switch (DIP switch) has to be left in position "Schwarzstahlspeicher" (factory setting).

When installing the heating element into a stainless steel or chrome steel boiler, the slide switch

(DIP switch) has to be switched to position "Edelstahlspeicher".

E l e c t r i c a l c o n n e c t i o n

The device is intended for fixed connection only and may be connected only to fixed cables. Select a

cable cross-section suitable for the power rating of the device. All poles of the device must be able to

be disconnected from the mains by means of an at least 3mm isolating distance. The PE wire must be

100mm longer than the other conductors.

I n t h e e v e n t o f t h e f o l l o w i n g t h e g u a r a n t e e i s v o i d :

- Not complying with this paperwork „Fitting instructions, user manual, and service"

- Not complying with the storage heater manufacturer's fitting instructions

- Technical modifications, repairs or tampering with the device (including exchanging the thermostat)

- Applications for which the device was not designed

- Incorrect operation and maintenance

- Not complying with directive VDI 2035

- Manipulations on the operating software

- Undocumented parameterizations via the documented interfaces

MV-012-6791.2

01.11.2021

www.askoma.com

Page 3