ASL INTERCOM BS 216 사용자 설명서 - 페이지 3

{카테고리_이름} ASL INTERCOM BS 216에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ASL INTERCOM BS 216 11 페이지. Dual channel master station
ASL INTERCOM BS 216에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지), 빠른 매뉴얼 (4 페이지)

페이지 인쇄

4.0

MAINS POWER

The BS 216 may be connected to the mains power outlet

to which other audio equipment is connected. The outlet

should have a clean earth. Avoid using mains power

outlets which also power dimmer controlled lighting

equipment.

The used AC power source can be anything from 100 -

240 V AC, 50/60 Hz. There is no need to adjust the unit to

the used mains voltage.

The power cord supplied with this unit carries the following

information label:

This appliance must be earthed

4.1

SAFETY EARTHING

The green-and-yellow wire of the mains cord must always

be connected to the electrical installation safety earth or

ground. It is essential for personal safety as well for proper

operation of the BS 216 and the other connected stations.

This wire is internally connected to all exposed metal

surfaces and any rack framework into which this unit might

be mounted is assumed to be connected to the same

grounding circuit.

4.2

POWERING UP

Powering up procedure:

Make sure that the red power switch on the left side of

the front panel is OFF.

Connect the power cord to the rear of the station.

Plug the other end of the power cord into a

PROPERLY GROUNDED outlet.

Turn on the power with the red button, the green power

LED will go on, indicating the station is active.

WARNING

IMPORTANT

The wires in this mains lead are colour coded in

accordance with the following code:

green and yellow

blue

Neutral

brown

Live

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured green-and-yellow must be

connected to the terminal in the plug which is marked

with the letter "E", or by the earth symbol which is

coloured green.

The wire which is coloured blue must be connected to

the terminal which is marked with the letter "N" or

coloured black.

The wire which is coloured brown must be connected

to the terminal which is marked with the letter "L" or

coloured red.

Those units that are supplied to the North American

market will have an integral moulded 3 pin connector

which is provided to satisfy required local standards.

Earth / safety ground