ASL INTERCOM PS 230 사용자 설명서 - 페이지 4

{카테고리_이름} ASL INTERCOM PS 230에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ASL INTERCOM PS 230 8 페이지. Dual channel remote speaker station
ASL INTERCOM PS 230에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지), 사용자 설명서 (13 페이지)

페이지 인쇄

VOLUME control knobs

To adjust the listen level for the headset and the

loudspeaker.

TALK buttons

To activate the gooseneck or headset

microphone. The large green LEDs indicate if the

microphone is 'on'.

Momentary switching:

If a TALK button is pushed and held, the

microphone signal is sent to the corresponding

intercom channel until the button is released.

Latched switching:

If a TALK button is pushed shortly it is

electronically latched and the microphone signal

is sent to the corresponding intercom channel.

If pushed again, the TALK button switches off.

Mic Mute if latched on:

After on the intercom channel a so-called MIC

Mute signal has been received from a PRO

Series master station or separate power supply,

the connection between microphone and intercom

channel is interrupted. By pushing the TALK

button the connection is restored again.

CALL buttons

These push buttons (one for each channel)

activate the call system.

By a momentary push a visual call signal is sent

to all stations connected to the corresponding

intercom channel and the call LEDs start flashing.

By holding a CALL button pushed for 2 seconds

the call buzzer is activated, provided there is no

'buzzer mute' on one or both intercom channels.

After the CALL button is released the LEDs

continue to flash for a further 2 seconds.

SIDE TONE LEVEL trimmers

These trimmers, one for each channel, are for

minimizing the speaker feeding back into the

PAGE 4

User Manual PS 230 / October 2013 © ASL Intercom BV

gooseneck microphone (unit feedback). They also

determine the level of your own voice as you hear

it in the speaker or headset.

SIDE TONE HI trimmers

These trimmers, one for each channel, have the

same purpose as trimmer #5, but solely for the

high frequencies.

Adjustment procedure for both side tone

trimmers, for each channel separately:

•

set trimmer in start position: fully clockwise

•

switch off the microphones of all

connected (speaker) stations

•

make sure there is no automatic speaker

attenuation (turn trimmer #6 fully

clockwise)

•

push the TALK button of the

corresponding channel

•

slowly turn up the listen volume

•

speak into the gooseneck microphone

•

adjust the speaker listen level of the

corresponding channel to a minimum by

turning the side tone trimmers counter

clockwise (first trimmer #4 and then

trimmer #5; repeat this a few times)

•

Connect a headset to the PS 230 (the

speaker and gooseneck mic are now

automatically disabled) and speak into the

headset microphone

•

Check whether the level of your voice in

the headset can(s) is sufficient. If not,

push up the listen level of the

corresponding channel a bit by turning

side tone trimmer #4 clockwise.

The trimmers operating area is between fully

clockwise and minimum level.

Adjusting the side tone does not affect the level of

your voice as it is heard by other stations.