ASL INTERCOM DANS01 설치 매뉴얼 - 페이지 6
{카테고리_이름} ASL INTERCOM DANS01에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASL INTERCOM DANS01 12 페이지. Ip65 dynamic ambient noise sensor
페이지 인쇄
5.
Choose the required cable entry point or points, and remove the M20 blanking plug(s) at the chosen
position(s); see
Figure
6.
If rear entry is preferred, the installer may drill holes in the rear of the back box as described below.
a.
Remove the terminal plate by unscrewing the four corner fixings shown in
Figure 2
POZI TAPTITE SCREWS
TERMINAL PLATE
b.
Drill a hole or holes in the back box for the cable gland or conduit entry. These should be in the
positions shown in
Figure 3
c.
Deburr the newly drilled holes.
d.
Re-fit the terminal plate; see
DANS01 – Installation Guide
1.
DANS01 terminal plate
4 x M3.5x6
Figure
3.
Rear cable entry drilling centres
BACK BOX (REAR VIEW)
160 mm
40 mm
DRILLING CENTRES
Figure
Issue: 02 complete, approved
60 mm
80 mm
2.
Page 6 of 12
Figure
2.
4 x blanking plugs shown as
example only.