ACR Heat HERITAGE N25 설치 및 사용 설명서 - 페이지 4

{카테고리_이름} ACR Heat HERITAGE N25에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Heat HERITAGE N25 10 페이지.

INSTALLATION INSTRUCTIONS

IMPORTANT INFORMATION

This appliance must be installed in line with current building regulations

either by a registered installer or in conjunction with your local Building

Inspector. If in doubt, please consult your stockist or local planning

office.

If installed incorrectly, this appliance could contribute towards serious

accidents and / or damage to your property and could invalidate your

warranty.

The manufacturer's responsibility is limited to the supply only of this

appliance.

We recommend that a fireguard is used in the presence of children and

old and / or infirm people for safety.

The installaer should comply with Health & Safety regulations.

Adequate facilities should be provided for handling the appliance.

Extra care should be taken to avoid accidents and breakage of the glass

panels.

Care should be taken to avoid fire cement contacting the skin. The

material is caustic and in the event of skin coming into contact with the

fire cement, wash off immediately with clean water.

BEFORE YOU INSTALL YOUR APPLIANCE

Make sure the chimney is in good working order and that the

recommended required chimney draft is obtained. You must also ensure

that there is sufficient fresh air supply within the room as per Building

Regulations. If insufficient fresh air is provided, this will lower the

atmospheric pressure within the room and may lead to poor combustion

and smoke leakage from the appliance. We recommend that a minimum

airbrick of 33cm squared is installed (54cm squared for installations with

flue draft stabilisers)

The doors on your appliance have been accurately fitted in our factory. In

case you do find a problem in operating the doors, please report back to

your stockist now and do not continue with the installation until advised

further. ACR Heat Products can not accept responsibility for incorrect door

alignment once the appliance has been installed.