Acer AC 711 사용자 설명서 - 페이지 2

{카테고리_이름} Acer AC 711에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer AC 711 7 페이지. Acer 17" monitor user manual ac 711
Acer AC 711에 대해서도 마찬가지입니다: 서비스 매뉴얼 (25 페이지), 빠른 시작 매뉴얼 (7 페이지)

페이지 인쇄

1. Specification

Federal Communications Commission

( FCC Statement )

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. T hese limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

n Reorientate or relocate the receiving antenna;

n Increase the separation between the equipment and receiver;

n Connect the equipment with a power socket on a circuit different from that to which the receiver is

connected;

n Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the manufacturers may void t he user's authority to

operate this equipment.

A shielded-type video signal cable is required in order to meet the FCC emission limits and also

to prevent interference to nearby radio and television reception. It is essential t hat only the

supplied power cord be used.

Use only shielded cables to connect I/O devices to this equipment.

Canadian DOC Notice

For Class B Computing Devices

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing

Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel

brouilleur du Canada.

Connecting the Monitor and Swivel Base

Place the monitor with its tube down on a stable

surface.

Align the four tabs of the swivel base with the

slots in the bottom of the monitor.

Insert the tabs into the slots of the monitor

Now slowly slide the swivel base toward the

front of the monitor till you hear the spring lock

click into place.

Removing the Monitor and Swivel Base

If you need to remove the swivel base, push the spring lock and then pull the swivel base away from the monitor.

Special attention should be paid to the control knobs and LED indicators on the front panel

NOTE:

when you place the monitor with its tube down. This will prevent damage to these control knobs and

LED indicators from excessive pressure.