Canon 9319A009AA 서비스 매뉴얼 - 페이지 15
{카테고리_이름} Canon 9319A009AA에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon 9319A009AA 22 페이지. Service manual
페이지 인쇄
(8-1. FAQ (Problems specific to the iP1000 and corrective actions) cont'd)
No.
*
Function
Phenomenon
8
B
Image
Smearing on printed side.
quality
9
B
Smearing on the backside, or
address side of postcards
10
C
Horizontal lines or uneven print
density at the trailing edge of
paper
11
C
Horizontal lines or uneven print
density due to LF roller feeding at
small pitch
*Occurrence level:
A: The phenomenon is likely to occur frequently. (Caution required).
B: The phenomenon may occur under certain conditions, but likeliness is assumed very low in practical usage.
C: The phenomenon is unlikely to be recognized by the user, and no practical issues are assumed.
Possible Call / Claim
- Smear on the printed side of paper
- Cannot print properly
- Paper edge crease
<Photo Paper Plus Double Sided>
- Smears on the already printed side
when printing the other side
<When printing the address side of
postcards>
- Smears on the address side
<When printing the message side of
postcards>
- Smears on the backside
- Cannot print to the bottom edge of
paper
- Lines or uneven print density appear
in the trailing edge of paper
- Cannot print properly
- Lines or uneven print density (on skin
tones and background)
- Cannot print properly
( 15 /21)
Corrective action
1. Correct the paper curl.
2. Recommend the user to conduct
printing in the print quality assurance
area. (In the iP1500, the head-to-paper
distance cannot be changed.)
1. Perform Bottom Plate cleaning from
the printer driver.
2. Clean the ribs on the platen with cotton
swabs/buds.
1. Recommend printing in the print quality
assurance area.
2. Change the print quality from standard
to high mode.
3. Try other paper (PP-101)
Change the print quality from standard to
high mode.
Cause
The edge of paper rises due when paper
is curled, causing the print head to rub
against the printed surface of paper,
resulting in smearing.
When borderless printing is conducted
continuously, ink mist attaches to the ribs
on the platen, and is transferred to the
backside of the following paper.
When the paper end comes off the pinch
roller, printing is performed without the
paper being held, preventing the ink drops
from being ejected in the correct
positions, resulting in unevenness.
Note: The problem is less noticeable than
that of the i320.
As the print media slightly slips while
being fed by the LF roller, printed areas
overlap, causing the problem.