Aktakom ASE-1203 운영 및 유지보수 매뉴얼 - 페이지 10
{카테고리_이름} Aktakom ASE-1203에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktakom ASE-1203 11 페이지. Intelligent lead free soldering station 2 in 1
페이지 인쇄6.2.1 Inspect and Clean the Tip
Caution: Never file the tip to remove oxide.
1. Set the temperature to 250℃.
2. When the temperature stabilizes, clean the tip with the cleaning sponge and
check the condition of the tip.
3. If there is black oxide on the solder-plated portion of the tip, apply new solder
(containing flux) and wipe the tip on the cleaning sponge. Repeat until the
oxide is completely removed. Coat with new solder. The solder protects the
tip from oxidation and prolongs the life of the tip.
4. If the tip is deformed or heavily eroded, replace it with a new one.
6.2.2 A De-tinned Tip
1. Why a "de-tinned" tip fails to work?
A de-tinned tip is one which cannot wet with solder. This exposes the plating to
oxidation and degrades the heat transfer efficiency of the tip.
2. The de-tinning is caused by:
1) Failure to keep the tip covered with fresh solder while not in use.
2) High tip temperatures.
3) Insufficient melting in soldering operations.
4) Wiping the tip on dirty or dry sponges and rags. (Always use a clean, wet,
industrial grade, sulfur-free sponge.)
5) Impurities in the solder, iron plating, or on the surfaces to be soldered.
6.2.3 To Restore a De-tinned Tip
Remove the tip form the solder handle and allow the tip to cool down.
Use the "▲"and "▼" button to change displayed value. Set the
password value in the same way described in "temperature setting". After
Page 11
selecting the password of three digit, press the"ON/OFF"button.
The input password is error
5. If the iron enters into normal work state after display shows the current
setting temperature for two seconds, this indicates the input password is
error, and the temperature setting can't be done.
The input password is correct
6. If the window shows
correct. After displaying about 4 seconds, it comes into the normal work
state, and the temperature setting and parameter setting will be admitted.
Input new password
7. When display window is showing
shows
, it indicates the iron comes into inputting new password
state. Press "▲"and "▼" button to change displayed value. See
"temperature setting".
Repeat the new password
8. When three digits are selected, press"ON/OFF"button, the display
window shows
, again. Now input the new password once again.
Repeat the same steps.
9. If the latest two passwords are the same, pressing"ON/OFF"button will
modify the password successfully. The new password is stored into the
memory.
10. If the latest two passwords are not the same, pressing"ON/OFF"button,
and the display window shows
(See the last 8~9 step). The changing of password is successful until the
latest two passwords are the same.
Note:
The word of password is 0 to 9, ten figures. If not, the input password is
invalid.
Because the password of the two work stations is one and only, after setting
the password of one station, the parameter setting of other station is locked
too.
, this indicates the inputting password is
, press the"ON/OFF"button, and
, it needs to rewrite new password.
Page 8